Ecoflex Underfloor Heating Cable Kit - 150W/m2 - Area to be Heated -  1.2 - 1.9m2

Ecoflex Underfloor Heating Cable Kit - 150W/m2

Part No: CK1

  • Area to be Heated - 1.2 - 1.9m2
  • Cable Length 16.77m - 225W Output

  • £69.48
    Part No: CK2

  • Area to be Heated - 2.0 - 2.9m2
  • Cable Length 28.9m - 350W Output

  • £87.18
    Part No: CK3

  • Area to be Heated - 3.0 - 3.9m2
  • Cable Length 39.21m - 525W Output

  • £97.98
    Part No: CK4

  • Area to be Heated - 4.0 - 4.9m2
  • Cable Length 54.76m - 700W Output

  • £128.48
    Part No: CK5

  • Area to be Heated - 5.0 - 6.4m2
  • Cable Length 65.01m - 875W Output

  • £145.38

    Description

    Flexel Ecoflex Underfloor Heating Cable Kit - 150W/m2 (approx)
  • Approximate installed loading - 150W/m2 - 7cm to 9cm cable spacing for optimum heat output
  • Ideal for smaller installations or in rooms with an irregular layout
  • The flexibility of the loose cabling system makes it possible to heat the maximum floor area including hard to reach areas.
  • Minimum cable spacing is 50mm, however it can be increased to a maximum of 150mm
  • Minimum spacing from the walls must be 50mm
  • Also available as a loose cable option (see Separates section)
  • Underfloor heating cables can be installed on top of either suspended timber floors or solid concrete floors enabling installation in all room types
  • Cables can also be installed under many floor coverings including: Ceramic, Natural Stone, Slate, Quarrystone, Porcelain, Marble, Limestone & Terracotta
  • Electrical requirements: very simple to install by following the instruction booklet included with each cable kit
  • Please note: The final electrical connections should be made by a qualified electrician in accordance with the current wiring regulations
  • All installations require an RCD (residual current device) for safe operation
  • Thermostat required (not included) see above for details
  • For larger areas that require heating - please ring for assistance
  • Image shows CK5 cable kit
    Ecoflex underfloor heating cable kits come as a complete heating system in a box. The kit includes:
  • Drum of heating cable, twin conductor with 3m "cold tail"
  • Floor primer and roller
  • High impact adhesive fixing tape
  • Thermostat floor probe conduit (thermostat not included)
  • Full installation instructions and guarantee
  • Specification

    Article CodeCK1

    This website uses 'cookies' to give you the best, most relevant experience. Using this website means you’re Ok with this. You can change which cookies are set at any time - and find out more about them - by following this link (or by clicking the cookie link at the top of any page).

    OK, I understand and accept