Flexel EcoFilmSet 160W/m2 U/floor Htg Element-1000mm Wide
Description
Flexel 1000mm Wide EcoFilmSet Underfloor Heating ElementThe complete electric underfloor heating solution for all laminate and timber floors
Easy to lay
Standard lengths between 2m and 8m, in 0.5m increments
Element lengths can be reduced on-site, if necessary, and are supplied as standard with 5m "cold tails"
Installation is completely dry and is a simple unrolling process
EcofilmSet comes pre-wired. Only a simple 2 wire electrical mains connection is required to provide gentle and safe heating comfort. Heat output is 160W per m2
Elements are ultrathin and have a minimum effect on finished floor levels; an important consideration when laying floating floors
Can be laid on most subfloors; concrete or timber when used in conjunction with Ecomax-Lite Thermal Insulation (not included)
Control options are available separately at additional cost
Also available in 300mm and 500mm widths - just select the roll width and nearest lengths to provide maximum floor coverage
Please Note: The final electrical connections should be made by a qualified electrician in accordance with the current wiring regulations
All installations require a 30mA RCD (residual current device) for safe operation
All elements require connection to the thermostat via a standard junction box
EcofilmSet is approved to the relevant International standard approval EN60335-2-96
10 year guarantee against manufacturing defects
Picture shows 500mm width
Before laying the EcofilmSet on either a suspended wooden floor or concrete sub-floor it is necessary to install a layer of Ecomax-Lite Thermal Insulation. This will minimise heat losses and ensure quicker heat-up times for the floor. It will also act as a means of sound deadening which is required for laminate floors.
Next roll out the pre-cut lengths of EcofilmSet taking care to locate the “cold tails” on the wall nearest the thermostat connection box. Trim to length as required and insulate trimmed ends as per instructions before taping the element into position. Never overlap the heating surfaces. Cover the total EcofilmSet installation with a layer of Flexel Polyester Vapour Barrier (PVB25) before laying the chosen floor covering.