Slimline Antique Brass Empty LED Dimmer

Part No: DSL670

Empty Plate and Knob

Part No: DSL671

Empty plate and 2 knobs

Part No: DSL672

Empty plate and 3 knobs

Part No: DSL673

Empty plate and 4 knobs

Part No: SN400M

Dims most types of LED loads


Acts as a 1 or 2 way switch but does not dim

Part No: MPINT

Intermediate dummy module that DOES NOT dim. 


Other items in this range

Show 57 more products


Build your own bespoke LED and standard Dimmer Plate Switch

  • Simply choose the plate and then select the dimming modules you require
  • Single plate dimensions: 86mm wide x 86mm high x 7mm deep
  • Double plate dimensions: 146mm wide x 86mm high x 7mm deep 
  • All switches can operate 1 or 2 way but you can only have 1 dimmer on any light fitting
  • If you have to 2 way switch a circuit only put a dimmer on one end, we also list a dummy dimmer which will facilitate this
  • Most dimmer plates will fit on a 25mm backbox but we always reccomend using a 35mm box so there is plenty of air


Article CodeDSL670

This website uses 'cookies' to give you the best, most relevant experience. Using this website means you’re Ok with this. You can change which cookies are set at any time - and find out more about them - by following this link (or by clicking the cookie link at the top of any page).

OK, I understand and accept