Flexel EcoFilmSet U/floor Htg Element-500mm Wide


Flexel 500mm Wide EcoFilmSet Underfloor Heating Element
  • The complete electric underfloor heating solution for all laminate and timber floors
  • Easy to lay
  • Standard lengths between 2m and 8m, in 0.5m increments
  • Element lengths can be reduced on-site, if necessary, and are supplied as standard with 5m "cold tails"
  • Installation is completely dry and is a simple unrolling process
  • EcofilmSet comes pre-wired. Only a simple 2 wire electrical mains connection is required to provide gentle and safe heating comfort.
  • Heat output is 130W per m2
  • Elements are ultrathin and have a minimum effect on finished floor levels; an important consideration when laying floating floors
  • Can be laid on most subfloors; concrete or timber when used in conjunction with Ecomax-Lite Thermal Insulation (not included)
  • Control options are available separately at additional cost
  • Also available in 300mm and 1000mm widths - just select the roll width and nearest lengths to provide maximum floor coverage
  • Please Note: The final electrical connections should be made by a qualified electrician in accordance with the current wiring regulations
  • All installations require a 30mA RCD (residual current device) for safe operation
  • All elements require connection to the thermostat via a standard junction box
  • EcofilmSet is approved to the relevant International standard approval EN60335-2-96
  • 10 year guarantee against manufacturing defects

    Before laying the EcofilmSet on either a suspended wooden floor or concrete sub-floor it is necessary to install a layer of Ecomax-Lite Thermal Insulation. This will minimise heat losses and ensure quicker heat-up times for the floor. It will also act as a means of sound deadening which is required for laminate floors.
    Next roll out the pre-cut lengths of EcofilmSet taking care to locate the “cold tails” on the wall nearest the thermostat connection box. Trim to length as required and insulate trimmed ends as per instructions before taping the element into position. Never overlap the heating surfaces. Cover the total EcofilmSet installation with a layer of Flexel Polyester Vapour Barrier (PVB25) before laying the chosen floor covering.
  • Specification

    This website uses 'cookies' to give you the best, most relevant experience. Using this website means you’re Ok with this. You can change which cookies are set at any time - and find out more about them - by following this link (or by clicking the cookie link at the top of any page).

    OK, I understand and accept