Flexel Ecofloor Underfloor Heating Mat - 200 W/m2

Part No: LDTS200-1.0
2.0m long x 0.50m wide
£58.18
Part No: LDTS200-2.0
4.0m long x 0.5m wide
£97.38
Part No: LDTS200-3.0
6.0m long x 0.5m wide
£133.38
Part No: LDTS200-4.0
8.0m long x 0.5m wide
£163.88
Part No: LDTS200-5.0
10.0m long x 0.5m wide
£201.88
Part No: LDTS200-6.0
12.0m long x 0.5m wide
£218.48
Part No: LDTS200-7.0

14.0m long x 0.5m wide

£247.18
Part No: LDTS200-8.0
16.0m long x 0.5m wide
£271.48
Part No: LDTS200-9.0
18.0m long x 0.5m wide
£297.48
Part No: LDTS200-10.0
20.0m long x 0.5m wide
£380.48

Description

Flexel EcoFloor 200W/m2 Underfloor Heating Mat
  • Combination of self-adhesive mesh with a heating cable pre-attached
  • Mat design enables fast installation and an even heat distribution across the whole floor
  • Mats are 500mm wide and available in a range of lengths
  • Mats have a twin conductor cable simplifying installation with a single 3m “cold tail” connection
  • Finished installation is controlled using an easy to use programmable thermostat
  • Also available in 150W/m2 heat outputs suitable for internal applications including kitchens, bathrooms & living areas
  • This 200W/m2 mat is recommended for use in conservatories or areas prone to high heat loss
  • Very simple to install by following the comprehensive instruction booklet included with each cable mat
  • Please Note: The final electrical connections should be made by a qualified electrician in accordance with the current wiring regulations
  • All installations require a 30mA RCD (residual current device) for safe operation
  • Rooms requiring more than two mats require connection to the thermostat via a standard junction box
  • It is recommended that consideration is given to floor insulation as an insulated floor will speed up heat up times and reduce running costs

    For Suspended Floors:
    When fitting Ecofloor to a timber sub-floor it is essential that you take the standard precautions to stabilise the floor and prevent floor movement. You must always over-board the timber floorboards or chipboard with a surface suitable for tiling. Flexel recommend Ecomax Insulated Tile Backer Board or primed 18mm WBP Plywood.
    For Solid Floors:
    For best performance it is recommended before fitting Ecofloor you fit a layer of Ecomax Insulated Tile Backer Board. This will minimise heat loss and ensure quicker heat-up times for the floor. Ecofloor can be laid directly onto an un-insulated floor, however this will slow heat-up times, increase running costs and is not recommended.
  • Specification

    Article CodeLDTS200-1.0

    This website uses 'cookies' to give you the best, most relevant experience. Using this website means you’re Ok with this. You can change which cookies are set at any time - and find out more about them - by following this link (or by clicking the cookie link at the top of any page).

    OK, I understand and accept