Antique Brass Empty LED Dimmer Switch - 1 Gang

Antique Brass Empty LED Dimmer Switch

Part No: 7MPRO-670

Empty Plate and Knob

£5.98
Part No: 7MPRO-671
Empty plate and 2 knobs
£6.48
Part No: 7MPRO-672

Empty plate and 3 knobs

£9.78
Part No: 7MPRO-673

Empty plate and 4 knobs

£10.38
Part No: SN400M

Dims most types of LED loads

£8.98
Part No: DUMMY DIMMER
Acts as a 1 or 2 way switch but does not dim
£6.38
Part No: MPINT
Intermediate dummy module that DOES NOT dim. 
£12.88

Description

Build your own bespoke LED and standard Dimmer Plate


  • Simply choose the plate and then select the dimming modules you require
  • If you would like it assembling please tell us configuration left to right in the comments box when checking out
  • Single plate dimensions: 86mm wide x 86mm high x 7mm deep
  • Double plate dimensions: 146mm wide x 86mm high x 7mm deep 
  • All switches can operate 1 or 2 way but you can only have 1 dimmer on any light fitting
  • If you have to 2 way switch a circuit only put a dimmer on one end, we also list a dummy dimmer which will facilitate this
  • Most dimmer plates will fit on a 25mm backbox but we always reccomend using a 35mm box so there is plenty of air

Specification

Article Code7MPRO-670
Barcode5025117007204

This website uses 'cookies' to give you the best, most relevant experience. Using this website means you’re Ok with this. You can change which cookies are set at any time - and find out more about them - by following this link (or by clicking the cookie link at the top of any page).

OK, I understand and accept