Bespoke CCT Dotless LED Flexible Tape 16.6w/m

1 Required for each piece of LED strip

Part No: 48001-89636


Part No: 48001-89637

Single colour remote handset to work with receiver RF-Z1C-REC-TOP6

Switch/control & dim up to 4 zones together or independently

Part No: 48001-89638

At least one receiver required per zone

12v 144w max load

24v 288w max load

3 Yr Guarantee

Part No: 48001-89640

Will power up to 6000mm of 16.6w tape



Easy to fit 24v LED strip on self adhesive flexible dotless tape, dotless means it will be very hard to see the individual LED's on the tape, even more so when used with an aluminium profile. CCT means you can switch between warm white, cool white and daylight. You will need a controller to do this.  Bespoke product cut to length in 50mm intervals and terminated ready to plug in to driver and go. If you are ordering more than 1 piece please put the lengths of each piece required in the comments box when checking out. Also you will need to order 1 termination and input cable per piece and relevant drivers.

  • To be ordered in 50mm intervals, eg: If you need 1250mm order 25 in the qty
  • IP20 so not suitable for bathrooms unless used with IP65 profile
  • Dimmable
  • Minimum length = 200mm. Maximum length = 5m
  • Width = 10mm
  • 1M = 16.6w= 826-847 Lumens per metre
  • Requires Mains 240v to 24v LED driver (not incl - see )
  • Requires termination and input cable (Please order 1 per individual strip length)
  • Important - Please note that this is a bespoke order product and as such is outside the realms of our normal returns procedure. Once order is placed for this item, goods can not be returned nor cancelled.


This website uses 'cookies' to give you the best, most relevant experience. Using this website means you’re Ok with this. You can change which cookies are set at any time - and find out more about them - by following this link (or by clicking the cookie link at the top of any page).

OK, I understand and accept