Satin Chrome Empty LED Dimmer Switch - 1 Gang

Satin Chrome Empty LED Dimmer Switch

Part No: 7MPRO-170
Empty Plate and Knob
Part No: 7MPRO-172
Empty plate and 3 knobs
Part No: 7MPRO-173
Empty plate and 4 knobs
Part No: IN10W
Dims most tungsten incandescent loads
Acts as a 1 or 2 way switch but does not dim
Part No: MPINT
Intermediate dummy module that DOES NOT dim. 


Build your own bespoke LED and standard Brushed Dimmer Plate

  • Simply choose the plate and then select the dimming modules you require
  • If you would like it assembling please tell us configuration left to right in the comments box when checking out
  • Single plate dimensions: 86mm wide x 86mm high x 7mm deep
  • Double plate dimensions: 146mm wide x 86mm high x 7mm deep 
  • All switches can operate 1 or 2 way but you can only have 1 dimmer on any light fitting
  • If you have to 2 way switch a circuit only put a dimmer on one end, we also list a dummy dimmer which will facilitate this
  • Most dimmer plates will fit on a 25mm backbox but we always reccomend using a 35mm box so there is plenty of air


Article Code7MPRO-170

This website uses 'cookies' to give you the best, most relevant experience. Using this website means you’re Ok with this. You can change which cookies are set at any time - and find out more about them - by following this link (or by clicking the cookie link at the top of any page).

OK, I understand and accept